Tale of Two Power Systems

Looking over a power monitoring dataset recently; we came across a site with a dual personality. The site in question had low total harmonic distortion (THD ~ 1.5%) from 4/1/17 up until 4/10/17 (specifically, at 2:00 pm). After that, the THD fluctuated much higher, rising as high as 5.4% (outside of manufacturer requirements for medical imaging equipment).

Tale2Power THD

A closer “before / after” look at the voltage and current waveforms provides more evidence, with visible notching on the voltage waveform “after”; monitored current showed some noise but was similarly low.

Tale2Power Waveforms Before Tale2Power Waveforms After
Before 4/10/17 After 4/10/17

Individual harmonics similarly supported the findings of the THD log, with all harmonics higher, and 5th harmonics exceeding 3%.

Tale2Power Harmonics Before Tale2Power Harmonics After
Before 4/10/17 After 4/10/17

Tale2Power NG RMS
Finally, the “before after” affect was also seen in the Neutral-Ground voltage – with noise voltages evident although the lower frequency voltages were not much higher.

Tale2Power NG Before Tale2Power NG After
Before 4/10/17 After 4/10/17

The funny thing is that the RMS voltage and the current of the device under test were not significantly different before / after the 4/10/17 date, in terms of RMS level or in terms of stability: sags, swells or fluctuations.
Tale2Power RMS

So what’s the scoop? We’re not on site, but odds are good that some facility load (we’re betting air conditioning, but could be other facility loads) got switched on at this time. Alternately, perhaps the facility transitioned to an alternative power source. But whatever the reason, this is clearly a tale of two power systems, and we’re curious about it!